External roller bearings are located at the motor end of the shaft and on a hinged cover at the discharge end for maximum support and vibration-free operation. When the end cover is hinged open, the shaft becomes a cantilever supported by a third externally-mounted roller bearing located between the motor-end bearing and material feed point, allowing internal components to slide freely from the opposite shaft end for thorough wash-down.

The screener is constructed of stainless steel finished to 3-A, FDA, BISSC, and other sanitary standards required for food, dairy, and pharmaceutical applications, as well as general chemical applications involving frequent screen changes/inspections or runs of multiple materials with no cross contamination.

Dry or moist bulk solid material is gravity-fed into the feed inlet and redirected into the cylindrical sifting chamber by means of a feed screw. Rotating helical paddles within the chamber continuously propel the material against the screen, while the resultant, centrifugal force on the particles accelerates

In addition to sifting and scalping of dry bulk materials, the screener can break up soft agglomerates and/or dewater moist solids or slurries.
 

On-size particles passing through screen apertures are funneled through a discharge housing equipped with an inspection door.

• Anti-blinding devices
• Bag Dump Station
• Clean-in-place (CIP)
• Twin centrifugal configuration
• Integral feeder
• Design, construction and finish to FDA, 3-A, BISSC, EEC and other sanitary standards
• Belt drive and Direct drive configurations
• Design, construction and finish to pharmaceutical specifications